# My beater is not centered?

The design of the Louët Jane beater leaves it to be easily bent or torqued out of center.  This can happen over time or accidently without even knowing.

If your beater is out of center, closer to one side of your loom than the other, or touching one side of your loom, try this fix.

It is a simple fix.    With warp on or off, lift your beater so it is parallel to the table and torque your beater in the direction needed.  (if the beater is practically touching the left side, torque the beater to the right)

This Louëtvideo shows how<br>

{% embed url="<https://youtu.be/cd7Xai9rsIs?si=ebRofGztDviyhbca>" %}


---

# Agent Instructions: Querying This Documentation

If you need additional information that is not directly available in this page, you can query the documentation dynamically by asking a question.

Perform an HTTP GET request on the current page URL with the `ask` query parameter:

```
GET https://learning.loftyfiber.com/floor-and-table-looms-purchasing-information-and-support/louet-floor-and-table-looms/louet-jane-loom/troubleshooting-the-jane-loom/my-beater-is-not-centered.md?ask=<question>
```

The question should be specific, self-contained, and written in natural language.
The response will contain a direct answer to the question and relevant excerpts and sources from the documentation.

Use this mechanism when the answer is not explicitly present in the current page, you need clarification or additional context, or you want to retrieve related documentation sections.