# Inserting and Removing Micro-SD Cards from the TT System Unit

To insert the micro-sd card, insert the micro-sd card with the metal strips down as shown below.  Then push the card into the slot.  Note that the card should be pushed straight in.

<figure><img src="/files/XEmo73PAEO2sAwU0lJrf" alt="" width="375"><figcaption><p>Inserting the Micro-SD Card</p></figcaption></figure>

To remove the micro-sd card, place your fingers over the edge and pull it the card straight out.   Note that there is no "spring action" on this device; simply pull to remove, don't push and pull.

The picture below shows the a Micro-SD card fully inserted.  There will be a small lip (about 2.5mm) extending from the case.

<figure><img src="/files/Utdu8xv5tOwzTAbnj9wg" alt="" width="375"><figcaption><p>Fully Inserted Micro-SD Card</p></figcaption></figure>


---

# Agent Instructions: Querying This Documentation

If you need additional information that is not directly available in this page, you can query the documentation dynamically by asking a question.

Perform an HTTP GET request on the current page URL with the `ask` query parameter:

```
GET https://learning.loftyfiber.com/tempotreadle/tempotreadle-automatic-tracking-for-your-loom/preparing-wif-files-for-your-project/inserting-and-removing-micro-sd-cards-from-the-tt-system-unit.md?ask=<question>
```

The question should be specific, self-contained, and written in natural language.
The response will contain a direct answer to the question and relevant excerpts and sources from the documentation.

Use this mechanism when the answer is not explicitly present in the current page, you need clarification or additional context, or you want to retrieve related documentation sections.